Kohler COMMAND CH18-745 User Manual download pdf (Page 205)

11.20

Section 11

Reassembly

Figure 11-71. Reinstalling SAM Module.

Install Electric Starter Motor

1. Install the starter motor using the two hex. flange

screws. See Figure 11-72. Some inertia-drive

starters have a pinion cover and spacers on the

starter bolts.

2. Torque the two hex. flange screws to 15.3 N·m

(135 in. lb.).

Figure 11-72. Installing Electric Starter Motor.

Figure 11-73. Connecting Leads to Starting Motor.

NOTE: If the engine uses a side mount muffler on the

starter side, be sure to tie the wires close to

the starter to avoid contact with hot exhaust

parts.

Install Fuel Pump

WARNING: Explosive Fuel

Gasoline may be present in the carburetor and fuel

system. Gasoline is extremely flammable and its

vapors can explode if ignited. Keep sparks and other

sources of ignition away from the engine.

1. Install the pulse style fuel pump and lines as an

assembly. Connect the pulse line to the

crankcase vacuum fitting or the valve cover,

whichever source is used.

NOTE: Pulse style fuel pumps may be made of

metal or plastic. See Figure 11-74. If a

new fuel pump is being installed, make

sure the orientation of the new pump is

consistent with the removed pump.

Internal damage may occur if installed

incorrectly.

2. Install the fuel pump using the two hex. flange

screws. Torque the screws to 2.3 N·m (20 in. lb.).

3. On models with a solenoid shift starter, connect

the leads to the solenoid. See Figure 11-73.

Cylinder Baffle Mounting Location

Blower Housing Mounting Location

1 2 ... 200 201 202 203 204 205 206 207 208 209 210 ... 217 218

No comments

Kohler COMMAND CH18-745 User Manual Page 205