Kohler K-4026-0 Installation Guide download pdf (Page 2)

Important Information

NOTE: This product is designed for installation with the electrical and water supplies located through

either the wall or the ﬂoor.

Grounding Instructions

•

This product should be grounded. In the event of an electrical short circuit, grounding reduces the

risk of electric shock by providing an escape wire for the electric current. This product is equipped

with a cord having a grounding wire with a grounding plug. The plug must be plugged into an

outlet that is properly installed and grounded.

WARNING: Risk of electric shock. Improper use of the grounding plug can result in a risk of

electric shock.

•

If repair or replacement of the cord or plug is necessary, do not connect the grounding wire to either

ﬂat blade terminal. The wire with insulation having an outer surface that is green with or without

yellow stripes is the grounding wire.

•

Check with a qualiﬁed electrician or service personnel if the grounding instructions are not

completely understood, or if in doubt as to whether the product is properly grounded.

•

This product is factory equipped with a speciﬁc electric cord and plug to permit connection to a

proper electric circuit. Make sure that the product is connected to an outlet having the same

conﬁguration as the plug. No adapter should be used with this product. Do not modify the plug

provided — if it will not ﬁt the outlet, have the proper outlet installed by a qualiﬁed electrician. If

the product must be reconnected for use on a different type of electric circuit, the connection should

be made by qualiﬁed service personnel.

Tools and Materials

Before You Begin

WARNING: Risk of electric shock. Disconnect power before servicing.

WARNING: Risk of electrical shock. Connect only to a properly-grounded, grounding-type

receptacle which is protected by a Ground-Fault Circuit-Interrupter (GFCI). Do not remove the

grounding pin or use a grounding adapter.

CAUTION: Risk of hazardous gases. If a new toilet is not installed immediately, temporarily place

a rag in the ﬂoor ﬂange opening.

NOTICE: The Canadian Electric Code requires receptacles installed in bathrooms to be located at least

39-3/8″ (1 M) from a bath or shower if practical, but in no case less than 19-11/16″ (500 mm). If the

installation is in Canada, install this unit in accordance with the Canadian Electrical Code, Part 1.

Masking

Tape

Pencil or Felt

Tip Marker

Assorted

Screwdrivers

Supply Stop

5/16" T-Bolts and Wax Seal

Drill and 1/4" bit

Caulk Gun

Caulk

Rags

Silicone Grease

or Soap

1221754-2-B 2 Kohler Co.

1 2 3 4 5 6 7 ... 39 40

Comments to this Manuals

No comments

Kohler K-4026-0 Installation Guide Page 2

Comments to this Manuals

Related products and manuals for Sanitary ware Kohler K-4026-0