Kohler K-97339-NA Installation Guide download pdf (Page 2)

Tools

Important Information

CAUTION: Risk of personal injury. Do not use the bath

ﬁller as a grab bar or support bar when entering or exiting

the bath. The bath ﬁller is not designed to support weight.

NOTICE: To avoid damage to the O-rings on the bottom of the

faucet, keep the faucet vertical and use care when installing the

faucet.

NOTE: A minimum operating pressure of 45 psi (310 kPa) is

required for proper operation. If a pressure of less than 45 psi (310

kPa) is present, contact a plumber or choose another faucet.

For use with automatic compensating valves rated at 1.6 gal/min

(6.1 l/min) or less.

Observe all local plumbing and building codes.

Shut off the water supply.

A drill bit is provided for installation to wood support. Use an

appropriate drill bit for other materials.

The dimensions given assume the spout and bath are mounted on

the same surface. Adjust the dimensions accordingly if the spout

and bath are mounted on different surfaces.

If this product is installed with an overﬂowing bath, the outer rim

of the bath should slightly overlap the 2x4 framing.

Installer supplied copper tubing must be 5/8″ OD (1/2″

Nominal).

Carefully review this document and any appropriate rough-in

sheets. Design the bath enclosure accordingly.

Sealant Tape

Plus:

• 3/16" Masonry Bit (for concrete installation)

• Conventional Woodworking Tools

• Plumbing Tools and Materials

1240535-2-D 2 Kohler Co.

1 2 3 4 5 6 7 ... 43 44

No comments

Kohler K-97339-NA Installation Guide Page 2