Kohler K-1124-GRA-0 Installation Guide download pdf (Page 5)

1. Prepare the Site

NOTICE: Do not support the bath by the rim.

NOTICE: Refer to the Roughing-in Guide packed with this product for proper minimum lbs/square foot

(kg/square meter) ﬂoor support loading.

NOTICE: Provide adequate ventilation and a minimum of 15 cubic feet (.4 cubic meters) in the installed

location for cooling the motor and to supply sufficient air for the blower. Do not install the blower motor

closer than 1″ (2.5 cm) from the wall or other objects.

Make sure the ﬂoor offers adequate support for your bath, and verify that the subﬂoor is ﬂat and

level.

Construct 2x4 or 2x6 stud framing designed for your particular installation.

Install an access panel to allow the blower motor to be serviced.

Position the plumbing according to the roughing-in information packed. Cap the supplies, and

check for leaks.

Showerhead

Blocking

Supply

Valves

Spout

Header

Over

Opening

Remove

bottom plate.

Kohler Co. 5 1040292-2-E

1 2 3 4 5 6 7 8 9 10 ... 47 48

No comments

Kohler K-1124-GRA-0 Installation Guide Page 5