Kohler K-706002-L-SH Installation Guide download pdf (Page 5)

2. Install the Bottom Side Lite Bracket

Insert the appropriate threshold ﬁller into the side lite bracket in the groove located on top of the

threshold. If the 7″ (17.8 cm) side lite bracket is used, use the 11″ (27.9 cm) threshold ﬁller. If the 13″

(33 cm) side lite bracket is used, use the 17″ (43.2 cm) threshold ﬁller. Position the ﬁller against the

wall on the same side that the side lite panel will be installed.

Identify the bottom side lite bracket. When placed in the correct position on the threshold, the

bracket weep slots will be towards the inside (wet side) of the shower, and the channel will be

towards the outside (dry side) of the shower (weep slots and channel will be on opposite edges for

the top side lite bracket).

Place the side lite bracket on the threshold, ﬂush against the wall and ﬂush against the threshold

ﬁller.

NOTE: Be careful not to drill through the receptor ledge.

Mark the hole location through the bracket hole and remove the bracket. Using the supplied 7/64″

drill bit, drill a hole through threshold at the location marked and clean out the ﬁlings.

Apply silicone sealant to the channel on the bottom of the bracket and place on the threshold at its

previous location. Secure the bracket to the threshold using #6-20 x 3/8″ screw.

#6-20 x 3/8" Screw

Threshold

Threshold Filler

Inside of Shower

Bracket Hole

Note:

Position weep slots towards

inside (wet side) of shower.

Position channel

towards outside (dry

side) of shower.

Bottom Side

Lite Bracket

If the 7" (17.8 cm) side lite bracket is used,

use the 11" (27.9 cm) threshold filler. If the

13" (33 cm) side lite bracket is used, use

the 17" (43.2 cm) threshold filler.

Weep

Slot

Apply silicone sealant to channel

located under bracket.

Kohler Co. 5 1011451-2-F

1 2 3 4 5 6 7 8 9 10 ... 39 40

No comments

Kohler K-706002-L-SH Installation Guide Page 5