Kohler K-101-PB Installation Guide download pdf (Page 4)

1. Prepare the Site

If not already installed, install or relocate the water supplies as

needed to conform to the roughing-in dimensions for your

particular installation.

Use thread sealant on all the threaded connections.

2. Freestanding Supply Installation

Remove the temporary plugs from the water supply couplings.

Replace the long rod with the short rod for Kohler models

K-710, K-711, K-712, K-726 and K-727. To determine the bath to

drain faucet measurement for your model bath refer to the

″Roughing-In″ section of this manual.

Thread the tee bracket into the hole in the back of the overﬂow

elbow.

Insert the rod into the tee bracket and secure with the setscrew.

Install the Supply Tubes

Loosen the setscrews in the pipe holder and ﬂange.

Carefully slide the plated supply pipe through the pipe holder

and ﬂange.

Thread the supply pipe into the supply rough-in and tighten it

with a strap wrench.

Tighten the setscrews in the pipe holder and ﬂange.

Rod

Setscrew

Pipe

Holder

Tee

Bracket

Overflow

Elbow

Plated Supply Pipe

Setscrew

Pipe

Holder

Tee Bracket

Flange

1008209-2-G 4 Kohler Co.

1 2 3 4 5 6 7 8 9 ... 51 52

No comments

Kohler K-101-PB Installation Guide Page 4