Kohler K-528-K-NA Installation Guide download pdf (Page 8)

3. Prepare the Site

NOTE: Horizontal wall installation is shown. The valve can also be wall-mounted vertically or mounted

to a horizontal surface. Refer to the ″Mounting Conﬁgurations″ section.

This product is designed to ﬁt within a minimum 14-1/2″ (368 mm) 2x4 stud cavity.

Install adequate bracing for mounting the valve. Notch the bracing as needed to accommodate the

inlets and outlets.

4. Install the Electrical Outlet

NOTICE: Do not install the valve under a whirlpool surround or any location where the temperature may

exceed 104°F (40°C). The valve and its integrated power supply is rated to operate in temperatures up to

104°F (40°C).

Install a 120 V GFCI electrical outlet within the stud framing, in close proximity to the valve. Locate

the outlet above the valve.

Cross Brace MountBoard Mount

Notch bottom brace.

14-1/2"

(368 mm) Min

2-3/4"

(70 mm)

Min

9-1/2"

(241 mm)

12-1/2"

(318 mm)

14-1/2"

(368 mm) Min

11-5/8"

(295 mm)

Drip Loop

Place the outlet

higher than

the valve.

1145587-2-B 8 Kohler Co.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 47 48

No comments

Kohler K-528-K-NA Installation Guide Page 8