Kohler K-1229-RAW-NY Instruction Manual download pdf (Page 6)

3. Install Electrical Outlet – United States and Canada

WARNING: Risk of electric shock. Connect the power supply to a properly grounded,

grounding-type receptacle protected by a Ground-Fault Circuit-Interrupter (GFCI) or Residual

Current Device (RCD). Do not remove the plug grounding pin. Do not use a grounding adapter.

Your bath with heated surface is equipped with a cord and plug. The power supply has been wired

at the factory. A qualiﬁed electrician must install a GFCI-protected, 120 V, 15 A, grounded outlet.

Locate the outlet behind the bath and within 24″ (610 mm) of the power supply.

Plug the power supply into this outlet.

Test Run the Bath

Check all electrical connections and make sure the electrical power to the bath is on.

Operate the user keypad to test the temperature settings.

For additional information on bath operation, refer to the ″Operating Instructions″ section.

GFCI-Protected

Receptacle

Power Supply

User

Keypad

Heated

Surface

1196030-2-B 6 Kohler Co.

1 2 3 4 5 6 7 8 9 10 11 ... 39 40

No comments

Kohler K-1229-RAW-NY Instruction Manual Page 6