Kohler K-1257-RH-0 Installation Guide download pdf (Page 6)

1. Prepare the Site

NOTICE: Unless otherwise speciﬁed, ﬂoor support under the whirlpool must provide for a minimum of

80 lbs./square foot (390 kg/square meter) loading.

NOTICE: Do not support the whirlpool by the rim.

Make sure the ﬂooring offers adequate support for your whirlpool, and verify that the subﬂoor is

ﬂat and level.

For Whirlpools without Apron:

The whirlpool should be installed in a drop-in installation. Construct 2x4 or 2x6 stud framing

designed for your particular installation. Provide for a 1/16″ (2 mm) gap between the bottom of the

whirlpool rim and the stud framing. Frame the ﬂoor, or construct a frame for a raised installation in

accordance with the roughing-in information packed with the whirlpool.

Carefully lay out and cut the rough deck material. Use the cut-out template if one is provided, or

refer to the roughing-in cut-out information.

For Whirlpools with Integral or Optional Apron:

The whirlpool should be installed in an alcove or corner installation, depending upon the model

chosen. Construct 2x4 or 2x6 stud framing designed for your particular installation. Construct a

frame in accordance with the roughing-in information packed with the whirlpool.

For All Installations:

Position the plumbing according to the roughing-in information packed. Cap the supplies, and

check for leaks.

2. Prepare the Whirlpool

Install the drain to the whirlpool according to the drain manufacturer’s instructions. Do not connect

the trap at this time.

Position a clean drop cloth or similar material in the bottom of the whirlpool. Be careful not to

scratch the surface of the whirlpool.

Position the rough

plumbing.

Frame the floor

according to the

roughing-in information.

Verify that the subfloor

offers adequate support,

and is flat and level.

Provide a 1/16" (2 mm) gap

between the whirlpool rim

and framing.

Construct 2x4 or 2x6

stud framing according

to the roughing-in

information.

Construct 2x4 or

2x6 stud framing

according to the

roughing-in

information.

Position the

rough plumbing.

Verify that the subfloor

offers adequate support,

and is flat and level.

1011092-2-D 6 Kohler Co.

1 2 3 4 5 6 7 8 9 10 11 ... 43 44

Comments to this Manuals

No comments

Kohler K-1257-RH-0 Installation Guide Page 6

Comments to this Manuals

Related products and manuals for Unknown Kohler K-1257-RH-0