Kohler K-1457-LV-47 Installation Guide Page 5

  • Download
  • Add to my manuals
  • Print
  • Page
    / 76
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 4
Lighted User Keypad
Power Icon Turns the whirlpool pump on and off. Icons illuminated in blue indicate available
modes/features. Modes which are operating will be illuminated in green.
Chromatherapy
Specific Color
Rotate the outer ring to select this mode. Press OK, press the up or down arrow to select a
color, then press OK again. Only one of the two keypads controls this mode.
Outer Ring Rotate the outer ring to the desired mode. The selected mode will flash blue.
Backjet Mode Rotate the outer ring to select this mode. Press OK, then press the up or down arrow to
increase or decrease the pulsing action. Rotate the outer ring to the Flexjet mode, press OK
to activate the mode, then press the up or down arrow on the keypad to increase or
decrease water flow to the backjets and all other active modes.
OK Activates the desired mode.
Flexjet Flow
Mode
Rotate the outer ring to select this mode. Press OK, then press the up or down arrow to
increase or decrease the jet water flow.
Up Arrow Increases the water flow when the Flexjet flow mode is active. Increases the pulse speed
when the neckjet or backjet mode is active.
Effervescence
Mode
Rotate the outer ring to select this mode, then press OK. The effervescence action will start
at the water flow volume last set in the Flexjet flow mode. Press the up or down arrow to
increase or decrease the water flow. Press OK while the effervescence mode is flashing to
turn off the effervescence ports.
Indicator Bar Displays the water flow volume in the Flexjet flow mode. Displays the pulse speed in the
neckjet or backjet mode.
Chromatherapy
Cycle
Rotate the outer ring to select this mode, then press OK. The chromatherapy lights will
automatically and continuously cycle through eight colors. One cycle through all eight
colors takes approximately one minute. Only one of the two keypads controls this mode.
Neckjet Mode Rotate the outer ring to select this mode. Press OK, then press the up or down arrow to
increase or decrease the pulsing action. Rotate the outer ring to the Flexjet mode, press OK
to activate the mode, then press the up or down arrow on the keypad to increase or
decrease water flow to the backjets and all other active modes.
Down Arrow Decreases the water flow when the Flexjet flow mode is active. Decreases the pulse speed
when the neckjet or backjet mode is active.
Heater Automatically engages when the power icon is selected. Rotate the outer ring until the
heater mode is flashing, then press OK to turn the heater off. Press OK again to turn the
heater back on.
Flexjet Flow Mode
Activates Mode
Selected
Rotate outer
ring to access
desired mode.
Chromatherapy -
Specific Color
Power
On/Off
Heater On/Off
Chromatherapy
Cycle
Decreases
Flow
Indicator Bar - Shows
Water Flow Volume or
Pulse Rate
Increases Flow
or Pulse Rate
Effervescence
Mode
Backjet Mode-
Adjust Pulse
Lighted User Keypad
Keypad above shows all features
available. Your keypad may vary
based on your whirlpool model.
Note:
Kohler Co. 5 1023236-5-C
Page view 4
1 2 3 4 5 6 7 8 9 10 ... 75 76

Comments to this Manuals

No comments