Kohler K-1457-LV-47 Installation Guide download pdf (Page 6)

Operation

NOTE: If the whirlpool is not operating properly, consult the ″Troubleshooting″ section of this guide

before calling a qualiﬁed service representative.

Whirlpool

Turn the jet trim fully counterclockwise. Position the jet nozzles so they face down toward the basin.

NOTICE: Do not allow the water temperature in the whirlpool to exceed 104°F (40°C). The heater will

automatically maintain the water temperature when the whirlpool is running, as long as the water

temperature does not exceed 104°F (40°C). The heater will disengage at higher temperatures.

Press the power icon to turn on the whirlpool pump and heater. Water will ﬂow at medium volume.

Press the up or down arrow icons to increase or decrease the water ﬂow. The indicator bar will

display the water ﬂow volume.

Adjust the jets for optimum air/water mixture. Turn the jet trim clockwise to reduce the ﬂow or

counterclockwise to increase the ﬂow. If desired, position the jet nozzles to direct the water ﬂow to

maximize your hydro-massage experience.

If desired, turn the heater off by pressing the heater icon. Press the button a second time to turn the

heater back on.

Press the power icon a second time to turn off the whirlpool pump and heater.

NOTE: The pump and heater will automatically stop after approximately 20 minutes of continuous

operation. If desired, press the power icon to reactivate the pump and heater.

Carefully exit the bath, then open the drain to empty the whirlpool.

Effervescence

Rotate the outer ring until the effervescence icon is ﬂashing, then press OK to activate the

effervescence ports. The water ﬂow volume will remain as previously set. Press OK while the

effervescence mode is ﬂashing to turn off the effervescence ports.

Chromatherapy

NOTE: The chromatherapy modes may be used with all modes of operation, even when the pump is not

operating.

Rotate the outer ring to select the chromatherapy mode, then press OK to activate the

chromatherapy lights. Press OK while the chromatherapy mode is active to turn off the

chromatherapy lights.

Fill with water at least 2" (5.1 cm)

above the highest jet.

Turn the jet trim ring

clockwise to

decrease the flow.

Position the jet

nozzles to direct

the water flow as

desired.

Turn the jet trim ring counterclockwise

to increase the flow.

1023236-5-C 6 Kohler Co.

1 2 3 4 5 6 7 8 9 10 11 ... 75 76

No comments

Kohler K-1457-LV-47 Installation Guide Page 6