Kohler K-9026-96 Installation Guide download pdf (Page 6)

4. Install the Plumbing

NOTE: Provide access to all plumbing connections to simplify future maintenance.

Locate rough plumbing for the drain according to the correct model’s roughing-in dimensions.

NOTE: If plumbing is to be located on the unﬁnished stud wall, install the supplies after the receptor is

installed.

Position the plumbing according to the roughing-in information. Cap the supplies and check for

leaks.

Install a drain pipe according to the roughing-in information.

Strap the supply connections to the stud framing.

If possible, provide an access at the back of the plumbing wall for servicing the supply and waste

piping.

Install the shower valving according to the manufacturer’s instructions. Do not install the trim at

this time.

5. Prepare the Receptor

WARNING: Risk of product or property damage. Do not support the shower receptor by the rim. The

weight of the shower receptor should be supported by the bottom.

CAUTION: Risk of property damage. If a watertight seal on the drain is not obtained, water damage

to the subﬂoor may occur.

Install the drain to the shower receptor according to the drain manufacturer’s instructions.

Clean the receptor to reduce the risk of surface damage.

Place a clean drop cloth or other similar material into the bottom of the receptor. Be careful not to

scratch the surface of the unit.

1009404-2-D 6 Kohler Co.

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

No comments

Kohler K-9026-96 Installation Guide Page 6