Kohler K-1418-G-0 Installation Guide download pdf (Page 7)

2. Construct the Site - Concrete

CAUTION: Risk of property damage. Do not support the bath by the rim. The bath must be

supported by the leveling blocks only.

NOTICE: Adequate ﬂoor support must be provided. Consult the roughing-in sheet packed with your bath

for speciﬁc ﬂoor loading requirements.

NOTICE: Provide adequate ventilation and a minimum of 15 cubic feet (.4 cubic meters) in the installed

location for cooling the motor and to supply sufficient air for the blower. Do not install the blower motor

closer than 1″ (2.5 cm) from the wall or other objects.

NOTE: This bath may be installed in a drop-in or an island installation. An island installation requires a

four side surround. In both instances, make sure the deck is supported by brick or concrete.

Make sure the ﬂooring offers adequate support for your bath, and verify that the subﬂoor is ﬂat and

level.

Provide access panels as required to service the blower motor and control.

Construct brick or concrete supports.

Provide a 1/16″ (2 mm) gap between the bath rim and the concrete or brick framing. Frame the

ﬂoor, or construct a frame for a raised installation, in accordance with the roughing-in information

packed with the bath.

Position the plumbing according to the roughing-in information packed. Cap the supplies, and

check for leaks.

Bath

Approved Tile Backing

Brick

Tile

Approved Tile Backing

Tile

1/16"

(2 mm)

Brick

Typical

Access

Panel

Install an access panel to allow

the blower to be serviced.

Bath may be installed next

to the wall or as an island

installation.

Kohler Co. 7 1035472-2-H

1 2 3 4 5 6 7 8 9 10 11 12 ... 71 72

No comments

Kohler K-1418-G-0 Installation Guide Page 7