Kohler K-1652-NA Installation Guide download pdf (Page 8)

Install the Piping (cont.)

Install copper tubing from the in-line water ﬁlter (if applicable) to the inlet on the steam

generator(s).

Connect the pressure relief valve to a drain line. The drain line should meet all applicable codes.

Before connecting the water inlet line, ﬂush the water line into a large pail to remove any silt or

other materials that may be in the line.

Make the ﬁnal connection of the water supply to the steam generator. Check for leaks.

NOTE: All Kohler steam generators are equipped with an automatic water ﬁll system. The water will stop

after the unit is full.

Turn on the water to ﬁll the unit.

If the steam outlet piping run exceeds 10 ft (3 m) or is exposed to cold areas, insulate the piping

with steam rated insulation.

1008019-2-J 8 Kohler Co.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 43 44

No comments

Kohler K-1652-NA Installation Guide Page 8