Kohler K-1418-G-0 Installation Guide download pdf (Page 18)

Test Run the Bath (cont.)

Ensure the cable ties or other clips are supporting the air piping and electrical harnesses at the bath.

Ensure any unused electrical connectors are supported above the ﬂoor.

Check all electrical connections. Verify the electrical power to the bath is turned on.

Ensure all PVC piping connections are tightened.

Conﬁrm the Blower Motor Operation

Remove the protective drop cloth from the bath.

Fill the bath to a level at least 2″ (5.1 cm) above the top of the highest airjet.

Press the power button on the user keypad.

Observe that the user keypad icons illuminate. The air ﬂow mode icon and the chromatherapy cycle

icon (if provided) will illuminate green. The Zone 1, Zone 2, and Zone 3 icons are also illuminated

green since all three zones are activated.

Observe that the blower motor starts at a midrange speed.

If provided, verify that all four chromatherapy lights are illuminated. The cycling of colors may not

be readily apparent as the cycle time may be rather long.

NOTE: The purge cycle mode cannot be selected while there is water in the bath.

Rotate the outer ring through each of the available icon positions.

As each icon is selected to activate each mode, verify the icon begins ﬂashing green. If the mode is

not operating, the icon will ﬂash blue.

As each icon is deselected, verify each icon stops ﬂashing.

Select and activate the air ﬂow mode icon.

Press the up or down button to verify the air ﬂow increases or decreases.

Stop the blower.

Check for water leakage at the bath, the bath drain, and the air harness.

Conﬁrm the Individual Zone Control

Select and deactivate Zone 1.

Verify the air stops ﬂowing in the corresponding zone.

Activate Zone 1.

Repeat for Zones 2 and 3.

Check all bath PVC connections for leaks.

Conﬁrm the Surge Mode Operation

NOTE: The surge mode cycles the speed of the blower motor between minimum and maximum settings,

as shown on the indicator bar on the user keypad. Six cycle times are available, ranging from about 10

seconds to about one minute. In this mode, the cycle time can be controlled using the up or down button

on the user keypad. The surge mode will operate with any zone or all zones selected.

Select and activate the surge mode.

Verify that the air ﬂow cycles between minimum and maximum.

Increase or decrease the speed of the surge cycle by pressing the up or down button.

Press the power button on the user keypad.

Operate the Chromatherapy Cycle (if equipped)

1035472-2-H 18 Kohler Co.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 71 72

No comments

Kohler K-1418-G-0 Installation Guide Page 18